HP P9000 Command View Advanced Edition Suite Software 7.4.1-00 CLI Reference Guide (TB581-96335, April 2013)

DescriptionStatusParameter name
Threshold1 of the THP/Smart pool (%)
The threshold1 of the THP/Smart pool is the usage rate of
the THP/Smart pool.
For P9500 whose microcode version is earlier than 70-01-
4X-XX/XX:
Specify a multiple of 5 in the range from 5 to 95.
For P9500 whose microcode version is 70-01-4X-XX/XX or
later:
Specify an integer in the range from 1 to 100.
For XP24000/XP20000:
Specify a multiple of 5 from 5 to 95.
You need to specify a value smaller than the one specified
for threshold2.
If this parameter is omitted, 70 is set.
Optional
threshold
Threshold2 of the THP/Smart pool (%)
The threshold2 of the THP/Smart pool is the usage rate of
the THP/Smart pool.
For P9500 whose microcode version is earlier than 70-01-
4X-XX/XX:
A value cannot be specified for threshold2.
For P9500 whose microcode version is 70-01-4X-XX/XX or
later:
If you specify this parameter, threshold2mode must
be set to 1.
Specify an integer in the range from 1 to 100.
You need to specify a value larger than the one spe-
cified for threshold.
If this parameter is omitted, 80 is set.
Optional
(P9500)
threshold2
Specify whether to use the value specified for threshold2
for the THP/Smart pool.
One of the following values can be specified:
• 0: Uses the value determined by the storage system.
• 1: Uses the value specified for threshold2.
You can specify 1 only when the microcode version is
70-01-4X-XX/XX or later.
If this parameter is omitted, 1 is set when the microcode
version is 70-01-4X-XX/XX or later, and 0 is set when the
microcode version is earlier than 70-01-4X-XX/XX.
Optional
(P9500)
threshold2mode
CLI Reference Guide 77