HP P9000 Replication Manager Software 7.2 User Guide

NOTE:
If command line execution from a user script times out, the task might remain in the Executing status.
If this happens, perform the following procedure before re-creating the task:
1. Restart the Application Agent service.
2. Update the task information.
3. Revise the CMDLINE and TIMEOUT settings in the user script.
Table 24 Script entries
Omit
Multiple
specifica-
tion
Meaning and specifiable valuesEntry name
Not allowedNot allowed
Specify YES.LOCAL_BACKUP
AllowedNot allowed
User processing section: Indicates the beginning of the "user pre-processing." In
this section, define commands to be executed before the backup operation.
[PRE_PROC]
AllowedNot allowed
User processing section: Indicates the beginning of the "user post-processing." In
this section, define commands to be executed after the backup operation.
[POST_PROC]
AllowedAllowed
Indicates the beginning of a command definition section.
• This item must be specified within a user processing section.
• If two or more command definitions are included in your code, they will be
executed individually in the order in which they are coded.
• When a value other than NOWAIT is specified in TIMEOUT, the next command
does not start executing until the executing command finishes or times out (in
other words, only one command executes at a time).
• When TIMEOUT=NOWAIT is specified, the subsequent command executes
without waiting for the preceding command to finish.
• The item specified in the command definition section is valid only on the
command definition section for the target command. The other command
definition sections are not affected.
[CMD]
User Guide 405