HP StorageWorks P9000 Replication Manager Software 7.1.1 Configuration Guide (TB584-96029, September 2011)

3. Execute the following command to re-create a database system on the disk:
installation-folder-for-P9000-Command-View-AE-Common-Component\bin\hcmdsdbremake
/databasepath new-database-recreation-destination-folder
NOTE:
Observe the following restrictions for folders/directories:
• Specify an absolute path for database-recreation-destination-folder of no more than 63
bytes.
• If you use a path delimiter as the last character of the destination name, the command
will fail.
NOTE:
The hcmdsdbremake command changes the port number used by HiRDB back to the
default (23032). If you are using a port number other than the default, you must reset the
port number after running the command. For details on how to change the port number,
see the HP StorageWorks P9000 Command View Advanced Edition Suite Software
Administrator Guide .
4. Execute the following command to register the database contents from step 1 into the database:
installation-folder-for-P9000-Command-View-AE-Common-Component\bin\hcmdsdbmove
/import /datapath data-input-and-output-destination-folder
Transferring the database to another disk (Windows MSCS)
The following describes the procedures for moving data when Microsoft Cluster Server (MSCS) is
used.
NOTE:
This procedure assumes that the HP StorageWorks P9000 Command View AE Common Component
service is already running.
Procedure on the executing node
1. On the executing node, make sure that the HP StorageWorks P9000 Command View AE Common
Component service is online, and that the executing node currently owns the service and shared
disk.
Troubleshooting114