HP StorageWorks XP Command View Advanced Edition Common Component Security Guide Description and Operator's Guide (T1780-96308, July 2009)

Creating a System
4 Creating a System
When the preparations required for system operation are complete, create the system. This chapter
describes how to create a system in the configuration evaluated based on ISO/IEC 15408 for HP
StorageWorks XP Command View Advanced Edition Common Component.
• Overview of System Creation (See section 4-1 )
• Installation (See section 4-2 )
• Setting Up an Environment (See section 4-3 )
• Settings Required after Installation of HP StorageWorks XP Command View Advanced Edition
Common Component (See section 4-4 )
• Setting Up the HP StorageWorks XP Command View Advanced Edition Common Component
Management Functions (See section 4-5 )
• Setting Up User Authentication Information (See section 4-6 )
• Using External Authentication Servers (See section 4-7 )
4-1 Overview of System Creation
4-1-1 System Creation Procedure
The following figure shows the procedure for creating a system.
Figure 4-1 Procedure for Creating a System
4-2 Installation
This section describes how to install HP StorageWorks XP Command View Advanced Edition
Common Component.
HP StorageWorks XP Command View Advanced Edition Common Component is installed when the
HP StorageWorks XP Command View Advanced Edition software is installed. To install the
management software selected as described in section 3-1 based on subsection 1-3-3 , the system
19