HP XP7 Smart Manager for Mainframe User Guide (TK916-96001, May 2014)

If you are not using SMP/E for the installation, you do not need to create a backup in the distri-

bution library.

Related topics

• Installing Smart Manager for Mainframe, page 28

• Settings required for using CLI commands (registration for authentication), page 33

• Setting RACF security for CLI commands, page 36

• Settings for using environment configuration commands, page 37

• Registering a user SVC, page 38

• Setting the operating environment for Smart Manager for Mainframe (setting environment variables

or system symbols), page 40

• Settings required to use Smart Manager for Mainframe on the ISPF panel, page 45

• Registering licenses, page 47

• Verifying the setup information, page 52

• Calculating required memory, page 53

• Settings required for collecting event logs, page 53

• Backing up Smart Manager for Mainframe to the distribution library, page 54

• Notes on setting up Smart Manager for Mainframe when Business Continuity Manager is already

installed, page 55

Installing Smart Manager for Mainframe

This section provides an overview and the procedure for installing Smart Manager for Mainframe.

Workflow for during installation

After transferring the load module for Smart Manager for Mainframe to a host machine, you can

install Smart Manager for Mainframe using SMP/E. Alternatively, you can install it directly in the

target library without using SMP/E.

The following figure illustrates the workflow when installing Smart Manager for Mainframe.

Figure 13 Workflow for during installation of Smart Manager for Mainframe