HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 Installation and Configuration Guide

• Verify that the file system mounted on the host matches the one defined in /etc/fstab.
• Verify that the network settings (such as those in the hosts file) are correct.
NOTE:
Do not try to install the Device Manager agent on an HP-UX workstation. If you do, the installation
fails and the following message appears:
ERROR: Could not apply the software selection "HDVMAgent" because there
are no product variations that are compatible with the destination
host(s).
• Do not create a symbolic link for any of the directories below. If you have already created a
symbolic link by using any of the directories below, do not install the Device Manager agent.
• /opt
• /opt/HDVM and its subdirectories
• /var
• /var/opt
• /var/opt/HBaseAgent and its subdirectories
• /var/opt/HDVM and its subdirectories
• /var/tmp
Installing agents
Follow the instructions for installing the Device Manager agent on your operating system.
Before you install the Device Manager agent, review the information in “Planning for Device Manager
agent installation ” on page 43, and “Agent installation prerequisites” on page 46.
Installing the Device Manager agent on a Windows host
You can install the Device Manager agent on a Windows host from the product DVD, and add the
agent-commands folder to the PATH variable.
TIP:
You can also download the Device Manager agent installer using the Tools menu in the GUI.
1. Log in to Windows as the administrator.
2. Insert the product DVD.
3. In the installation window, click Install next to Device Manager Agent.
If the installation window does not display automatically, run the following command:
DVD-drive:\AGENTS\HDVM\Windows\setup.exe
NOTE:
To install the Device Manager agent and automatically configure the appropriate settings for
Replication Manager operation, click Install (next to Replication Manager add-on).
Agent installation50