HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 Installation and Configuration Guide

Default ValueDetailsProperty Name
FALSE
Specify whether to continue
the installation when there is
insufficient unused capacity:
• TRUE: Continue the install-
ation
• FALSE: Stop the installa-
tion.
HINST_IGNORE_CAPA-
CITY_CHECK
FALSE
Specify whether to continue
the installation when the host
name or IP address that was
specified in
HINST_IPADDRESS is not
communicating with the
network.
• TRUE: Continue the install-
ation.
• FALSE: Stop the installa-
tion.
HINST_IGNORE_NETWORK-
ING_CHECK
FALSE
Specify whether to continue
the installation when there is
insufficient virtual memory.
• TRUE: Continue the install-
ation.
• FALSE: Stop the installa-
tion.
HINST_IGNORE_VIRTU-
AL_MEMORY_CHECK
Notes:
1. program-files-folder indicates the following location:
• For Windows x86: The folder specified in the Windows system environment variable %ProgramFiles%
• For Windows x64 or IPF: The folder specified in the Windows system environment variable %Pro-
gramFiles(x86)%
2. When installing in a cluster environment, default values are not specified automatically. You must explicitly
specify values. When installing on the standby node, you do not need to specify this property.
3. When installing in a cluster environment, you must specify this property on both the executing and standby
nodes.
4. If you perform an installation on the standby node in a cluster environment, databases are not backed
up or exported.
5. If you specify this property in a cluster environment, it is ignored.
Prerequisites for Command View AE Suite server unattended installation
Before performing an unattended installation of Command View AE Suite server, review system
requirements information.
1. Run Tiered Storage Manager tasks when upgrading from 7.1.0 or earlier:
• If there are incomplete tasks (standby, running, being cancelled), go to the Tasks & Alerts tab
and execute or cancel the tasks. After upgrading, register the canceled tasks as new.
2. Determine the values that are set during installation
Installation and Configuration Guide 63