HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

GetStorageArray (subtarget=PortController)
GetStorageArray (subtarget=PortController) obtains the information about port controllers.
Parameters
Table 59 GetStorageArray (subtarget=PortController) command parameters
DescriptionStatusParameter name
Specify PortController.
Required
subtarget
Serial number of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
model
Controller ID of the port controller in the storage system
Specify this parameter when you want to obtain information about
a specific port controller. If you specify this parameter, you must
also specify the model and serialnum parameters. If
controllernum and controllername are omitted, port
controller information is obtained for the specified storage system.
Do not specify controllernum and controllername at the
same time. If they are specified at the same time, an error will
occur.
Optional
controllernum
Controller name for port controller of storage system
Specify this parameter when you want to obtain information about
a specific port controller. If you specify this parameter, you must
also specify the model and serialnum parameters. If
controllernum and controllername are omitted, port
controller information is obtained for the specified storage system.
Do not specify controllernum and controllername at the
same time. If they are specified at the same time, an error will
occur.
Optional
controllername
Specific information about the port controller you intend to obtain
Available values are IPAddress and
PairedPortController. You can specify either one or both
of these values.
The information about IPAddress and
PairedPortController is valid for the NAS configuration.
Optional
controller-
subinfo
Parameter values to obtain in advance
serialnum and model: Obtain these values from the execution result of the GetStorageArray
command. In the execution result, use the arrayType value or the displayArrayType value to
specify the model parameter, and use the serialNumber value to specify the serialnum parameter.
Device Manager CLI command reference158