HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatusParameter name
Over provisioning warning threshold (%)
This is a threshold value related to the over-provisioning percent.
#4
The following values can be specified when modifying the
threshold value:
For P9500:
Specify an integer from 0 to 65534. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
Optional
overprovision-
ingwarning
#1, #2,
#3
Over provisioning limit threshold (%)
This is a threshold value related to the over-provisioning percent.
#4
The following values can be specified when modifying the
threshold value:
For P9500:
Specify an integer from 0 to 65534. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#4
exceeds the specified threshold value, you cannot
create a THP volume.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#4
exceeds the specified threshold value, you cannot
create a volume for Thin Provisioning Software or assign
volumes for Thin Provisioning Software to a pool for Thin
Provisioning Software.
Optional
overprovi-
sioninglimit
#1,
#2, #3
Device number of the logical unit(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Optional
adddevnums
#1, #2
CLI Reference Guide 173