HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

ModifyPortController
ModifyPortController supports changing characteristics of a PortController.
NOTE:
This command can be used only with XP24000/XP20000, XP12000/XP10000/SVS200, and
XP1024/XP128.
Parameters
Table 67 ModifyPortController command parameters
DescriptionStatusParameter name
Serial number of the port controller's storage systemRequired
serialnum
Model of the port controller's storage systemRequired
model
Number of the port controller
Specify either ctrlid or controllername. Do not specify
both parameters at the same time. If they are specified at the
same time, an error will occur.
Optional
ctrlid
Port controller name
Specify either ctrlid or controllername. Do not specify
both parameters at the same time. If they are specified at the
same time, an error will occur.
Optional
controllername
Mode value of the port controller
Specify either of the following values:
• 1: Normal
• 2: High Speed
Required
adaptermode
Parameter values to obtain in advance
serialnum and model: Obtain these values from the execution result of the GetStorageArray
command. In the execution result, use the arrayType value or the displayArrayType value to
specify the model parameter, and use the serialNumber value to specify the serialnum parameter.
ctrlid: Obtain this value from the execution result of the GetStorageArray
(subtarget=PortController) command. Execute this command by specifying only the model
and serialnum parameters, and PortController for the subtarget parameter. In the execution
result of this command, the controllerID value appears under An instance of
PortController. Use this controllerID value to specify the ctrlid parameter.
controllername: Obtain this value from the execution results of the GetStorageArray
(subtarget=PortController) command. In the execution results, displayName is displayed
below An instance of PortController. Specify this value as controllername.
CLI Reference Guide 185