HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

RefreshStorageArrays
The RefreshStorageArrays command refreshes storage system configuration information.
For storage systems that are managed by Device Manager, configuration information that is created
or modified from the Remote Console, Remote Web Console, or RAID Manager is added to or updated
in the Device Manager server database each time this command is executed. Execute this command
regularly to keep the Device Manager server database up to date.
NOTE:
To refresh only one storage system, use the AddStorageArray command. When the storage system
already exists, the AddStorageArray command performs a re-discovery operation on the storage
system and refreshes the registered information on the Device Manager server database.
Parameters
Table 69 RefreshStorageArrays command parameter
DescriptionStatusParameter name
Either of the following values can be specified to determine how
storage systems are refreshed:
• 1: Refreshes storage systems sequentially.
• 2: Refreshes multiple storage system in parallel.
The default is 1.
Optional
refreshmode
Interval time in minutes from storage system re-discovery
completion to start of next storage system re-discovery
Only specify this parameter when refreshmode=1 (when
storage systems are refreshed sequentially). An error will occur
if this parameter is specified when refreshmode=2.
You can specify a value from 0 to 2147483647.
The default is 0.
Optional
interval
The total number of volumes that can be refreshed at the same
time
Only specify this parameter when refreshmode=2 (when
multiple storage system are refreshed in parallel). An error will
occur if this parameter is specified when refreshmode=1.
You can specify a value from 1 to 100000.
The default is 16000.
Optional
maxldevs
Parameter values to obtain in advance
maxldevs: For this parameter, use the numberOfLUs and numberOfMfLDEVs values displayed
in the execution results of the GetStorageArray command. The numberOfLUs and
numberOfMfLDEVs values are displayed below An instance of StorageArray. Select the
StorageArray instance that has the largest numberOfLUs and numberOfMfLDEVs values when
added together and plug those values into the following formula to calculate the value to specify for
maxldevs:
Device Manager CLI command reference190