HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatusParameter name
Model of the path's storage systemRequired
model
Name of the HostInfo
You can use a character string of 1-50 bytes for the name.
Required
hostname
IPv4 IP address of the hostOptional
ipaddress
IPv6 IP address of the hostOptional
ipv6address
Mount point on the host file system corresponding to the pathOptional
mountpoint
Port that the path is on
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
port
Port name that the path is on
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
portname
Domain ID of the path
This parameter can be specified in decimal and hexadecimal. If
you specify a hexadecimal number, add the 0x prefix.
The execution results are output in decimal.
Required
domain
Device number of the path
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200 or XP1024/XP128,
use the xx:yy format, where xx is the CU number, and yy is
the LDEV number. For P9500 or XP24000/XP20000, use the
ww:xx:yy format, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If you omit
ww, the LDKC number is regarded as 0.
The execution results are output in decimal.
Required
devnum
Host SCSI bus numberRequired
osscsibus
Virtualized host SCSI IDRequired
osscsiid
Virtualized host LUNRequired
oslun
Port WWN on the host bus adapterOptional
portwwn
Type of the file systemOptional
filetype
Name of the file systemOptional
filename
LUN size in MBOptional
size
Percent of the LUN in useOptional
percentused
CLI Reference Guide 215