HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

Format
When obtaining information about a replication controller pair:
hdvmcli [URL] GetReplicationControllerPair [options]
masterserialnum=serial-number-of-the-storage-system-containing-the-MCU
mastercontrollerid=CU-number-of-the-MCU
remoteserialnum=serial-number-of-the-storage-system-containing-the-RCU
remotessid=SSID-of-the-RCU
[mastermodel=model-of-the-storage-system-containing-the-MCU
remotefamily=family-of-the-storage-system-containing-the-RCU
remotepathgroupid=path-group-ID-of-the-RCU]
When obtaining information about all replication controller pairs:
hdvmcli [URL] GetReplicationControllerPair
Parameters
Table 101 GetReplicationControllerPair command parameters
DescriptionStatusParameter name
Serial number of the storage system that contains the main control
unit (MCU)
Optional
#
masterserial-
num
CU number of the MCU
Optional
#
mastercontrol-
lerid
Serial number of the storage system that contains the remote
control unit (RCU)
Optional
#
remoteserial-
num
SSID of the RCU
Optional
#
remotessid
Model of the storage system that contains the MCU
Optional
#
mastermodel
Family of the storage system that contains the RCU
Optional
#
remotefamily
Path group ID of the RCU
Optional
#
remotepathgrou-
pid
#
The following describes the parameter combinations that can be specified:
You need to specify the masterserialnum, mastercontrollerid, remoteserialnum,
and remotessid parameters at the same time. If you do not specify them at the same time, an
error will occur.
If you specify the mastermodel, remotefamily, or remotepathgroupid parameter, you
also need to specify all other parameters (masterserialnum, mastercontrollerid, re-
moteserialnum, remotessid, mastermodel, remotefamily, and remotepathgroupid).
If you do not specify them at the same time, an error will occur.
If you omit all the parameters, the command will obtain the information about all replication con-
troller pairs.
CLI Reference Guide 275