HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionAttribute
Type of the Thin Provisioning volume
One of the following values is output for P9500 or XP24000/XP20000:
• -1: Non-THP volume
• 0: THP volume
• 1: THP pool volume
-1 is output for other storage systems.
thpType
Usage of on the THP volume (KB)
One of the following values is output for P9500 or XP24000/XP20000:
• When the logical unit does not consist of THP volumes: The same value as
capacityInKB.
• When the logical unit consists of THP volumes: Usage of on the THP volumes.
-1 is output for other storage systems.
For P9500 or XP24000/XP20000, note the following points on the value that is
output for THP volume usage:
• When the THP volumes are not assigned to a THP pool, 0 is displayed.
• When the operator is a partitioned storage manager, -1 is output.
• Volume capacity is allocated from the logical unit in units of tens of megabytes,
so, when the usage rate of the logical unit reaches 100%, the value of con-
sumedCapacityInKB might not match the value of capacityInKB.
• This value might increase significantly depending on the combination of the
file system and the OS of the host that is using the THP volumes. For details,
see the Thin Provisioning documentation.
consumedCapa-
cityInKB
Pool ID of the Thin Provisioning
One of the following values is output for P9500 or XP24000/XP20000:
• When the logical unit consists of THP volumes: Pool ID of the THP pool to which
the THP volumes are assigned.
#1, #2
• When the logical unit consists of THP pool volumes: Pool ID of the THP pool
that contains the THP pool volumes.
#2
• For other volumes : -1 is output.
#1 When the THP volumes are not assigned to a THP pool, -1 is displayed.
#2 When the operator is a partitioned storage administrator, -1 is displayed.
-1 is output for other storage systems.
thpPoolID
Usage rate threshold of the virtual volumes
One of the following values is output for P9500 or XP24000/XP20000:
• When the logical unit consists of THP volumes: usage rate threshold value of
the THP volumes
#1, #2
#1 When the THP volumes are not assigned to a THP pool, -1 is displayed.
#2 When the operator is a partitioned storage administrator, -1 is displayed.
• For volumes other than THP volumes : -1 is output.
-1 is output for other storage systems.
threshold
Currently, this information does not apply to storage systems (-1 is output).tcaPoolID
The name of the parity group to which the logical unit belongs
arrayGroupName
Device Manager CLI command reference304