HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)
DescriptionAttribute
Display name of the highest device number among the applicable LUs in the MCU
This value is output in one of the following formats:
For P9500 or XP24000/XP20000:
The value is output in the ww:xx:yy format, where ww is the logical DKC
number, xx is the CU number, and yy is the LDEV number.
For XP12000/XP10000/SVS200 or XP1024/XP128:
The value is output in the xx:yy format, where xx is the CU number and yy
is the LDEV number.
displayMasterEnd-
DevNum
Display name of the lowest device number among the applicable LUs in the MCU
The output format is the same as displayMasterEndDevNum.
displayMaster-
StartDevNum
Display name of the highest device number among the applicable LUs in the RCU
The output format is the same as displayMasterEndDevNum.
displayRemoteEnd-
DevNum
Display name of the lowest device number among the applicable LUs in the RCU
The output format is the same as displayMasterEndDevNum.
displayRemoteSt-
artDevNum
This item is not output.
pairPortType
#2
Currently, this information does not apply to storage systems (-1 is output).
bandwidth
#2
Minimum number of paths between the MCU and RCU
If the storage system that contains the MCU is P9500, XP24000/XP20000, or
XP12000/XP10000/SVS200, one of the following values is output:
1 to 8: The minimum number of paths between the MCU and RCU
-1 is output for other storage systems.
numOfMinConnec-
tion
#2
Currently, this information does not apply to storage systems.
nickname
#2
#1
If the GetReplicationControllerPair command is executed by specifying only the mas-
terserialnum, mastercontrollerid, remoteserialnum, and remotessid parameters,
the value for objectID will be invalid.
#2
If the GetReplicationControllerPair command is executed by specifying only the mas-
terserialnum, mastercontrollerid, remoteserialnum, and remotessid parameters,
the remoteArrayFamily, remotePathGroupID, pairPortType, numOfMinConnection,
and nickname attributes will not be output.
ReplicationGroup instance
The ReplicationGroup instance is output when the following commands are executed:
• “AddReplication” on page 260
• “DeleteReplication” on page 272
• “GetHost” on page 223
CLI Reference Guide 321