HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)
systemDisk=0
encrypted=-1
*****: The values are encoded by the CLI.
AddPool
AddPool creates a THP pool in a targeted storage system.
NOTE:
• This command can be used only with P9500 and XP24000/XP20000.
• The attributes of the Pool instance, thresholdVolForewarn and thresholdVolOverwarn,
which were output as the execution results of this command, have changed to overProvision-
ingWarning and overProvisioningLimit, respectively. Check and, if necessary, revise
the script settings that you use in version 6.3 or later.
Conditions a logical unit must satisfy to be used as a THP pool volume :
• It has a capacity of 8 GB or more.
• It is not a LUSE volume.
• It is not a paired volume created with Business Copy Software, Continuous Access Software, or
Continuous Access Journal Software.
• It is not an Auto LUN Software reserved volume.
• It is not a pool volume or a journal volume.
• It has a status of Normal or Normal(Quick Format).
• It is not a Thin Provisioning Software virtual volume.
• It is not a system drive.
• It has a guard mode of Read/Write.
• It has an emulation type of OPEN-V.
• It is not a command device.
• It does not have a Cache Residency Manager set.
• It does not have a path.
• If more than one logical unit is specified, all of them must have the same CLPR number.
• If more than one logical unit is specified, all of them must have the same cache mode.
The following conditions apply only to P9500 with a microcode version earlier than 70-02-00-XX/XX:
• If more than one logical unit is specified for a THP pool, internal volumes and external volumes
cannot be mixed together.
• If more than one logical unit is specified for a THP pool, all of them must have the same RAID
level.
• If more than one internal volume is specified for a THP pool, up to three types of logical units with
different drive types or rotational speeds can be used.
#
However, if the microcode version is earlier than 70-01-40-XX/XX, logical units that have different
drive types or rotational speeds cannot be used for a THP pool.
• To specify more than one logical unit for a pool for Smart Tiers, external volumes cannot be used.
The following conditions apply only to P9500 with a microcode version of 70-02-00-XX/XX or later:
CLI Reference Guide 65