HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatusParameter name
Threshold2 of the THP pool (%)
The threshold2 of the THP pool is the usage rate of the THP
pool.
For P9500 whose microcode version is earlier than 70-01-
4X-XX/XX:
A value cannot be specified for threshold2.
For P9500 whose microcode version is 70-01-4X-XX/XX or
later:
If you specify this parameter, threshold2mode must
be set to 1.
Specify an integer in the range from 1 to 100.
You need to specify a value larger than the one spe-
cified for threshold.
If this parameter is omitted, 80 is set.
Optional
(P9500)
threshold2
Specify whether to use the value specified for threshold2
for the THP pool.
One of the following values can be specified:
• 0: Uses the value determined by the storage system.
• 1: Uses the value specified for threshold2.
You can specify 1 only when the microcode version is
70-01-4X-XX/XX or later.
If this parameter is omitted, 1 is set when the microcode
version is 70-01-4X-XX/XX or later, and 0 is set when the
microcode version is earlier than 70-01-4X-XX/XX.
Optional
(P9500)
threshold2mode
Over provisioning warning threshold (%)
This is a threshold value related to the over-provisioning
percent.
#2
Specify a threshold value used to issue an advance warning.
For P9500:
Specify an integer from 0 to 65534. You need to spe-
cify a value smaller than the one specified for overpro-
visioninglimit.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to spe-
cify a value smaller than the one specified for overpro-
visioninglimit.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
Optional
overprovisioning-
warning
#1
Device Manager CLI command reference68