HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

DescriptionStatusParameter name
Over provisioning limit threshold (%)
This is a threshold value related to the over-provisioning
percent.
#2
Specify a threshold value used to issue an excess limit
warning.
For P9500:
Specify an integer from 0 to 65534. You need to spe-
cify a value larger than the one specified for overpro-
visioningwarning.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
If you specify a threshold value and the over-provision-
ing percent
#2
exceeds the specified threshold value,
you cannot create a THP volume.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to spe-
cify a value larger than the one specified for overpro-
visioningwarning.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
If you specify a threshold value and the over-provision-
ing percent
#2
exceeds the specified threshold value,
you cannot create a volume for Thin Provisioning Soft-
ware or assign volumes for Thin Provisioning Software
to a pool for Thin Provisioning Software.
Optional
overprovi-
sioninglimit
#1
Device number of the logical unit(s)
Specify this parameter as a decimal number or
colon-delimited hexadecimal number in the format
ww:xx:yy, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If ww
is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Required
devnums
Specify whether to create the pool for Smart Tiers.
One of the following values can be specified.
• enable: Creates the pool for Smart Tiers.
• disable: Creates the pool for Thin Provisioning Soft-
ware.
If this parameter is omitted, enable is set.
Optional
(P9500)
tiercontrol
Specify whether to automatically execute performance
monitoring and hardware tier relocation.
If you specify this parameter, you must also specify
tiercontrol=enable.
One of the following values can be specified.
• enable: Performs automatic execution.
• disable: Does not perform automatic execution.
If this parameter is omitted, enable is set.
Optional
(P9500)
automigration
CLI Reference Guide 69