HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1 CLI Reference Guide (TB581-96051, May 2011)

Parameters
Table 27 AddStorageArray command parameters
DescriptionStatusParameter name
IP address
Specify the IP address of the storage system.
For P9500 and XP24000/XP20000, this parameter can be
specified by using an IPv6 IP address.
Required
ipaddress
Family of the storage systemRequired
family
Display name of the storage system family
You cannot omit this parameter when using the command to
perform initial registration of information.
Required or option-
al
displayfamily
User ID
Specify the user ID used to access the storage system.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can omit
this parameter when updating information, if you do not change
the user ID.
Required or option-
al
userid
#
User password
Specify the user password used to access the storage system.
You cannot omit this parameter when using the command to
perform initial registration of information. However, you can omit
this parameter when updating information, if you do not change
the user password.
Required or option-
al
arraypasswd
#
#
If P9000 Command View AE Suite products are used to manage copy groups defined in a device
group, due to a RAID Manager limitation, be sure to specify character strings of 63 characters
or less for userid and arraypasswd.
Parameter values to obtain in advance
family and displayfamily: Obtain the values of these parameters from the execution results of
the GetServerInfo command. Use the arrayFamily value or the displayArrayFamily value
displayed in the execution result to specify the family parameter, and use the displayArrayFamily
value to specify the displayfamily parameter.
Command execution example
In this example, the AddStorageArray command accesses the storage system family (family:
XP1024/128, IP address: 172.16.45.1) and detects the storage systems in the storage system
family. The command specifies the user ID (root) and the user password (rootpass). Information
about the detected storage systems is registered in the Device Manager database.
hdvmcli AddStorageArray -o "D:\logs\AddStorageArray.log" ipaddress=172.16.45.1
family=XP1024/128 userid=root arraypasswd=rootpass displayfamily=XP1024/128
Device Manager CLI command reference74