HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)
11. On both the executing and standby nodes, change settings so that the following services start
manually.
• HBase Storage Mgmt Common Service
• HBase Storage Mgmt Web Service
• HCS Device Manager Web Service
• DeviceManagerServer
• HP StorageWorks XP Tiered Storage Manager
In the Services panel, open the properties of each service, and then change Automatic to Manual
in Startup Type.
12. Using the cluster software, register resources.
For details about how to register cluster resources, see “Setting up Microsoft Cluster
Service” on page 169 or “Setting up Microsoft Failover Cluster” on page 172.
Removing P9000 Command View AE Suite from a cluster
This section describes how to remove P9000 Command View AE Suite from the management servers
in a cluster configuration.
NOTE:
In the cluster management application, services are displayed with the resource names that were set
for them when they were registered as resources.
To remove P9000 Command View AE Suite from a cluster:
1. Move the owner of the resource group in which the P9000 Command View AE Suite product is
registered from the standby node to the executing node.
2. In the cluster management application, take the following services offline:
• HP StorageWorks XP Tiered Storage Manager
• DeviceManagerServer
• HCS Device Manager Web Service
• HBase Storage Mgmt Web Service
• HBase Storage Mgmt Common Service
3. Stop the P9000 Command View AE Suite product services.
Select Start > All Programs > HP P9000 Command View Advanced Edition Suite > Manage
Services > Stop.
4. In the cluster management application, take the following services offline:
• HiRDB/ClusterService _HD0
Setting up a cluster environment182