HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Installation and Configuration Guide (TB581-96063, September 2011)

value-that-is-enabled-in-the-system
,
initial-value-of-the-OS
}
+ value-for-Common-Component
+ value-for-Device-Manager
+ value-for-Tiered-Storage-Manager
+ value-for-Replication-Manager
,
value-for-HiRDB
}
NOTE:
Max {x, y, z} indicates the maximum value among x, y, and z.
Related topics
• Setting kernel parameters and shell restrictions (Linux), page 22
• Recommended Red Hat Enterprise Linux /etc/security/limits.conf values, page 25
• Modifying kernel parameter values and shell restrictions, page 30
Recommended Red Hat Enterprise Linux /etc/security/limits.conf values
Before installing P9000 Command View AE Software on a Red Hat Enterprise Linux system, set the
shell restriction values for the /etc/security/limits.conf file. Set the shell restrictions for both
soft and hard settings.
NOTE:
The soft value must be less than or equal to the hard value.
The appropriate values for each of these settings depend on which of the following P9000 Command
View AE Software products you are installing:
• Common Component
• Device Manager
• Tiered Storage Manager Software
• Replication Manager Software
The following tables show the shell restriction values you need to set. The formula for calculating these
values follow the tables.
Table 8 Shell restriction values for /etc/security/limits.conf (1/2)
Common Com-
ponent
HiRDB
Operating Sys-
tem Initial Value
Installer Check
Value
Shell Restriction
572134410241596nofile (soft/hard)
Installation and Configuration Guide 25