HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Installation and Configuration Guide (TB581-96063, September 2011)

If a property is not specified, the default value is used. Table 19 shows these default values.
Table 19 Data set in HDVMAgent.conf
Default valueDetailsProperty Name
None
Specify the IP address or host name of the Device
Manager server.
serverIP (required)
2001Specify the port number of the Device Manager server.serverPort (required)
D
Specify the interval of HiScan.
• H: Once an hour
• D: Once a day
• W,SUN: Once every Sunday
• W,MON: Once every Monday
• W,TUE: Once every Tuesday
• W,WED: Once every Wednesday
• W,THU: Once every Thursday
• W,FRI: Once every Friday
• W,SAT: Once every Saturday
• N: No interval
HiScanPeriod (required)
2:30
If you specify a value other than N for HiScanPeriod,
specify the timing for executing the HiScan command
using one of the following methods:
When specifying execution of the HiScan command
at a scheduled time, use the following format:
• Once an hour: Specify the time as mm.
• Once a day: Specify the time as hh:mm.
• Once a week: Specify the time as hh:mm.
When specifying execution of the HiScan command
at random times:
Specify this option in an environment where multiple
hosts are connecting to the Device Manager server to
execute the HiScan command at random times on the
hosts. This can decrease the load on the Device
Managers.
Specify the HiScan start and end time in the following
format:
• Once an hour: Specify the start and end time as
mm-mm.
• Once a day: Specify the start and end time as
hh:mm-hh:mm.
• Once a week: Specify the start and end time as
hh:mm-hh:mm.
If the start time is later than the end time, the end time
is set for the next day or hour (example: 23:00-1:00
or 45-15).
If the start time and the end time are the same,
HiScan executes as if you had specified a scheduled
time.
HiScanSchedule (option-
al)
Performing unattended installation and removal70