HP StorageWorks P9000 Replication Manager Software 7.1.1 User Guide (TB584-96030, September 2011)

2. The following functions are not supported:
• License usage and alert settings
• Remote path settings
3. The following functions are not supported:
• V-VOL management
• Deletion of copy pairs related to remote paths
• HORCM_LDEV format output of configuration definition files
4. The following functions are not supported:
• Monitoring of HAM copy pairs of XP24000/XP20000
5. HORC takeover (batch recovery) not supported
6. The following functions are not supported:
• Manage near-line SAS disks (disk type not shown)
• Display volume ownership
• Manage HP P9500
7. The following functions are not supported:
• Specify CTGID in Pair Configuration Wizard
• Display encrypted HDD in volume attributes
• Meter-based licenses
• Manage 256K LDEVs
8. The following functions are not supported:
• Displaying or monitoring copy groups defined in storage and changing the copy pair status.
• Virtual command devices
• Differential updating by storage system.
9. The following functions are not supported:
• Redundancy for pair management servers
• New hardware support
• Volume capacity display
• New range of controller pair bandwidth vales
When the displayed information depends on the system configuration
In Replication Manager, displayed information might be limited by the system configuration. The
following describes such limitations separately for open systems and mainframe systems.
For open systems
In open systems, if a Device Manager agent is not installed on a host, the IP address and mount point
of the host cannot be obtained and therefore are not displayed.
In addition, if Device Manager servers at multiple sites remotely copy data between storage system
volumes that the servers manage, n/a is displayed because the following information cannot be
acquired if the storage system is XP512/XP48:
• LDEV number of a secondary volume
• Name of the storage system to which a secondary volume belongs
Exceptions446