HP StorageWorks XP Command View Advanced Edition software Device Manager server installation and configuration guide (web version) (T1780-96078, March 2008)

Device Manager network configuration
39
2-5 Setting up the environment of a server
machine that has multiple NICs
If the server machine on which Device Manager has been installed has multiple NICs, when you
specify an IP address in the Device Manager settings, specify the IP address of the NIC that
belongs to the network to which web client is connected. Do not specify the host name.
This section describes the network settings required for the configuration shown in
Figure 2-6.
Figure 2-6 Configuration example using a server machine that has two NICs
2-5-1 Setting up a network
If you set up the configuration shown in Figure 2-6, set up routers, the client machine, and the
server machine so that the following devices can communicate with each other as shown by the
arrows in the figure:
• XP12000/XP10000/SVS200 and the machine used for web client
• XP12000/XP10000/SVS200 and the server machine on which Device Manager has been
installed (the server machine whose IP address is 10.0.0.100 in the figure)
2-5-2 Setting up the Device Manager server
When you specify an IP address for a Device Manager property, specify the IP address of the NIC
that belongs to the network to which the client connects. The settings for the configuration in
Figure
2-6 is as follows:
Setting for the Device Manager server property:
For the server.http.host property, specify the IP address of the host on which the web
server function of Device Manager is used:
server.http.host=10.0.0.100
For details about the Device Manager properties, see Chapter
8.