HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 Installation and Configuration Guide

,
initial-value-of-the-OS
}
+ value-for-Common-Component
+ value-for-Device-Manager
+ value-for-Tiered-Storage-Manager
+ value-for-Replication-Manager
,
value-for-HiRDB
}
NOTE:
Max{x, y, z} indicates the maximum value among x, y, and z.
Related topics
• About setting kernel parameters and shell restrictions (Linux), page 22
• Recommended Red Hat Enterprise Linux 5 /etc/security/limits.conf values, page 25
• Recommended Red Hat Enterprise Linux 6 /etc/security/limits.conf values, page 26
• Modifying kernel parameter values and shell restrictions, page 32
Recommended Red Hat Enterprise Linux 5 /etc/security/limits.conf values
Before installing Command View AE Suite on a Red Hat Enterprise Linux system, set the shell restriction
values for the /etc/security/limits.conf file. Set the shell restrictions for soft and hard settings.
NOTE:
The soft value must be less than or equal to the hard value.
These settings depend on which Command View AE Suite products you are installing:
• Common Component
• Device Manager
• Tiered Storage Manager
• Replication Manager
The following tables show the shell restriction values you need to set. The formula for calculating these
values follow the tables.
Table 8 Shell restriction values for Red Hat Enterprise Linux 5 /etc/security/limits.conf (1/2)
Common Com-
ponent
HiRDB
Operating Sys-
tem Initial Value
Installer Check
Value
Shell Restriction
572134410241596nofile (soft/hard)
Installation and Configuration Guide 25