HP XP P9000 Replication Manager Software 7.5.0-00 User Guide (TB584-96070, July 2013)

Alert completion
Alerts are automatically marked as Completed according to the criteria in the following table.
Table 7 Alert completion conditions
Completion criteriaMonitored condition
When current usage is less than or equal to the usage
(%) specified for the alert.
• Pool usage for each pool
• Journal usage for each journal group
• License usage
• Sidefile and journal volume usage
The write latency time must be less than or equal to
the time specified by the user for the alert to be com-
pleted.
Write latency time (C/T delta)
When the status of the copy pair transitions out of the
state specified for the alert.
Copy pair status
When all of the pairs contained in the copy group are
marked Completed. (Even if the status of pairs in the
copy group changes again, the copy group alert re-
mains Completed.)
Copy group status
Alert retention
By default, alerts older than 30 days are routinely deleted regardless of whether they have been
completed. As a result, Not Completed alerts older than 30 days are deleted and a new notification
for the alert is sent during the next scheduled monitoring operation.
Alert limits
You can register a maximum of 1,000 alert settings. You can add monitoring targets to existing alert
settings or edit existing alert settings (including deleting monitoring targets). If you specify multiple
monitoring targets for a single alert, the total number of targets specified for all alerts cannot exceed
1,000. Templates can be used to specify alert settings (useful when specifying the same settings for
many targets). You can register a maximum of 10 templates.
To reduce performance impact, the maximum number of detected pairs and pairs listed in an alert
(or email notification) for a copy group is 10, displayed in ascending order of source IDs. When the
number of pairs is greater than 10, the notice More than 10 pairs were detected is displayed
in the output.
User Guide 127