HP XP P9000 Replication Manager Software 7.6.0-00 Application Agent CLI Reference Guide

NOTE:
The backup information in the backup catalog is managed based on using the copy group as a key.
Depending on the backup method, you might not be able to perform restoration, even though the
backup data exists on the secondary volume. For further information, see the notes on running
Application Agent in the HP P9000 Replication Manager Software Application Agent CLI User Guide .
Note the following when restoring backup data obtained using VSS in units of Information Stores
when using Exchange Server 2003 or Exchange Server 2007:
When restoring backup data in units of Information Stores, if you specify both an Information Store
name and a storage group name, operations will occur as described below:
- If you specify a storage group name and an Information Store name of the same storage group, an
error will occur.
- If you specify a storage group name and an Information Store name of different storage groups,
the backup data is restored in units of storage groups and Information Stores respectively.
If you specify an Information Store name of data other than backup data obtained using VSS, an
error will occur.
If you omit an Information Store name and specify storage-group-name\, an error will occur.
When you want to specify an Information Store name, check the value displayed in
INFORMATIONSTORE of the drmexgcat command and specify exactly the same Information Store
name.
At restoration, this command dismounts all Information Stores within the storage group to which the
specified Information Store belongs.
If the restoration target disk contains Information Store files that are not restoration targets, an error
will occur.
If the restoration target disk contains data from different storage groups, an error will occur.
Return Values
0: Normal termination
Any value other than 0: Termination with an error
Examples
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000001:
PROMPT> drmexgrestore 0000000001 -resync
KAVX0001-I The drmexgrestore command will now start.
KAVX1805-I The information store will now be dismounted.
Storage group name = STR1
KAVX1700-I Restore processing will now start.
KAVX1701-I Restore processing has finished.
KAVX1806-I The information store will now be mounted.
Storage group name = STR1
KAVX0002-I The drmexgrestore command will now end.
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000003, and then performs roll-forward recovery:
Basic commands216