HP XP7 Command View Advanced Edition Mainframe Agent Installation and Configuration Guide (TK981-96005, May 2014)

Operation commands
This section describes the commands used for XP7 mainframe agent operation. For details on the
symbols used to explain the command syntax, see Table 25. For details on the command syntax
elements, see Table 26.
Starting XP7 mainframe agent
To start XP7 mainframe agent, use the START command.
XP7 mainframe agents reside on the system, and run in accordance with the definition of the YKPRMxx
initialization parameter. You can start multiple XP7 mainframe agents.
Because XP7 mainframe agent uses the TCP/IP protocol to communicate with HP XP7 Command View
Advanced Edition products, always start the IBM Communications Server before starting XP7 mainframe
agent. If you do not do this, the YKY315I message will be displayed and XP7 mainframe agent will
not start.
Format
START
1
cataloged-procedure-for-startup-name[.identification-name]
[,MEMBER=member-name]
[,SYSOUT=output-class]
Operands
cataloged-procedure-for-startup-name
Used to specify a name for the cataloged procedure for startup for the XP7 mainframe agent you
are going to start.
identification-name
Used to specify an identification name of the cataloged procedure for startup. This operand
uniquely identifies each job when the same cataloged procedure for startup name is used for
multiple jobs.
MEMBER=member-name
Used to specify a member name of the initialization parameter.
If omitted, the standard member name specified in the cataloged procedure for startup is used.
SYSOUT=output-class
Used to specify an output class for the output list. If omitted, the output class is automatically de-
termined based on the system settings.
Example
To start an XP7 mainframe agent with the following conditions, use one of the commands shown
below:
• Name of the cataloged procedure: YKAGENTD
• Identifier: YK
• Member name of the initialization parameter: YKPRM10
• Output class: X
Using XP7 mainframe agent68