HP XP7 Command View Advanced Edition Mainframe Agent Installation and Configuration Guide (TK981-96005, May 2014)

Explanation and actionsMessage textMessage ID
No copy pair was discovered in the specified range.
Check the operating range and status of the copy pair that
you want to acquire, and then execute the YKP2A command
again. If the copy pair status is Simplex, the YKP2A
command does not detect any copy pair.
No copy pair was dis-
covered.
YKY902I TSO
A parameter specification is invalid or missing.
Check the following and then execute the command again.
• Make sure the required parameter indicated by para-
meter-name was specified.
• Make sure the value specified in the required parameter
indicated by parameter-name is valid.
• Make sure the same DAD ID is specified for the primary
storage system side and secondary storage system side
of the DEVN parameter.
parameter-name
Name of the invalid or missing parameter
Missing or invalid para-
meter: parameter-name
YKY910E TSO
An error occurred during execution of the YKP2A command.
See the explanation corresponding to the message ID of the
error message indicated by message-text and take
appropriate action. Also see the additional information
indicated by message-value and message-severity
and take appropriate action. If the problem is not resolved,
contact maintenance personnel.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space is
displayed.
message-severity
Additional information about the error message
If no additional information is available, a space is
displayed.
The error messages message-text, message-value,
and message-severity are displayed in the TSO/E
terminal. Depending on the length of the error messages,
they might extend over several lines.
Error occurred during
execution. Cmd=info
msg=message text:
message value: message
severity
YKY912E TSO
No copy pair information was acquired from the volume
having the device number indicated by device-number.
There might not be a volume for the specified device
number. If the volume exists, check the channel settings.
device-number
Device number assigned to the volume from which no
copy pair information was acquired
No information was ac-
quired for
DEVN=device-number
YKY920W TSO
Installation and Configuration Guide 91