HP Storage Provisioning Manager (SPM) version 2.1 User Guide

3. Click the Capabilities tab.
The capability settings are displayed.
4. To edit these settings, click Edit Network.
The Edit Network window appears.
5. On the Capabilities tab, make any necessary changes. When all changes are complete, click
Apply. If additional changes are required on other tabs, click the appropriate tab. When
finished, click OK.
Viewing and modifying network security settings (Security tab)
To view or modify the security settings of a network:
1. In the Navigation tree, select Networks under the Resources heading.
The list of available networks appears in the content pane.
2. From the content pane, select the appropriate network.
The properties for the selected network are displayed.
3. Click the Security tab.
The basic settings are displayed.
4. To view the access control settings, click Access Control....
The Access Control window appears.
5. To edit the access control settings, click Edit Array, then click Access Control.... Make the
necessary changes and click OK.
6. To view effective permissions, click Effective Permissions....
The Effective Permissions window appears. When finished, click OK.
7. To edit additional security settings, click Edit Network.
The Edit Network window appears.
8. On the Security tab, make any necessary changes. When all changes are complete, click
Apply. If additional changes are required on other tabs, click the appropriate tab. When
finished, click OK.
Removing a network
Networks can be removed from the catalog if they do not contain zones on which a service depends
and if they do not contain endpoints on which any resource in SPM depends.
To remove a network:
NOTE: If a network is being used to fulfill the requirements of a storage service, that service
becomes Nonconformant if the network is removed from the SPM catalog. The service remains
Nonconformant until the network is imported back into the SPM catalog, the service has been
reconfigured, and a new candidate has been selected and activated.
1. In the Navigation tree, select Networks.
The list of available networks appears in the content pane.
2. From the content pane, select the appropriate network.
The properties for the selected network are displayed.
3. Click Remove Network at the bottom of the window. (Alternatively, right-click the volume
service and select Remove Network.)
The Remove Network verification dialog box appears.
4. Click Remove Network in the verification box.
Managing networks 43