HP P6000 Replication Solutions Manager User Guide (T3680-96089, October 2012)

Launching the device manager
Access HP P6000 Command View from the replication manager. Each time you use this action in
the same replication manager session, a new window for HP P6000 Command View is opened.
Considerations
• You can only use the GUI to launch the device manager. The action is not available unless
an individual resource is selected (highlighted) in the replication manager content pane.
• You must know the security credentials (user name and password) to log on to HP P6000
Command View.
Procedure
1. In the navigation pane, select DR Groups, Storage Systems, or Virtual Disks.
2. On a List or Tree tab, select any storage resource.
3. Select Actions > Launch the Device Manager.
A new browser window opens.
4. Respond to the security alert message, and then log on to HP P6000 Command View.
Listing individual resource events
Display the events for an individual resource.
Considerations
• You can only use the GUI.
• Applies only to individual DR groups, storage systems, and virtual disks.
Procedure
1. In the navigation pane, select resource type.
2. On the List tab, select the specific resource whose events are to be displayed.
3. Select Actions > List events.
An events window for the resource opens.
Low-level refreshing DR groups
Perform a low-level refresh of the virtual disks and log disk in a DR group. See virtual disks Low-level
refresh.
Considerations
• You can use the GUI or CLUI. See DR groups Actions cross reference.
Procedure
This procedure uses the GUI.
1. In the navigation pane, select DR Groups.
2. On the List tab, select the DR group whose virtual disks and log disk properties are to be
updated.
3. Select Actions > Low-Level Refresh.
The Confirmation Action window appears.
4. To continue, click OK.
The properties of the virtual disks and log disk in the DR group are updated.
Working with DR groups 71