HP P6000 Replication Solutions Manager CLI Reference (T3680-96071, June 2012)

Unmount the storage from the enabled host. If you use this option, the mount_point
switch is required.
unmount_volume
Specifies the user name for the account that the storage administrator created on
the host before installing the HP Replication Solutions Manager host agent software.
username
For more information, see the HP P6000 Replication Solutions Manager Installation
Guide.
SET HOST_VOLUME
The SET HOST_VOLUME command modifies host volume properties.
Syntax
s[et] host_vol[ume]|hostvol|hv <host_volume name>
{{ext[end]}
[extend_s[ize}|es=<value by which to extend in gb>]}
{{shr[ink]}
[shrink_s[ize}|shs=<value by which to shrink in gb>]}
Switches
Extends a host volume the amount specified in the extend_size switch.extend
Specifies the value (in GB) by which to extend the host volume.extend_size
Shrinks a host volume the amount specified in the shrink_size switch.shrink
Specifies the value (in GB) by which to shrink the host volume.shrink_size
SET JOB
The SET JOB command modifies job properties and controls job execution. Job controls include
abort, continue, pause, and run. If a job is run and returns results greater than 64 KB, the results
are truncated.
Syntax
set job <job name or instance name or id>
{ [ab[ort]]
[cont[inue]]
[des[cription]=<new description>]
[disable_s[chedule]|ds=<scheduleid>]
[enable_s[chedule]|es=<scheduleid>]
[name=<new name>]
[pause] }
| { {run}
| [mode={validate|normal|skip_validation}]
| [nowait]
| [wait] }
Switches
Stops the job operation.abort
Resumes the job instance. If an instance name is not specified, the continue operation
applies to the most recent job instance.
continue
NOTE: The continue switch does not wait for the current job to complete before
resuming. To do that, you must include the run and wait switches with the
continue switch.
SET HOST_VOLUME 31