FibrChanl-03 (fcoc) B.11.31.1209 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

This document provides information about the B.11.31.1209 release of the FibrChanl-03 (fcoc)
Fibre Channel Mass Storage Driver for HP-UX 11i v3.
FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3
overview
This release of the document for the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 (version B.11.31.1209) documents defect fixes and version changes.
New and changed features in this release
New features
There are no new features in this release.
Known problems fixed in this version
These issues have been fixed in the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 September 2012 (AR1209) release.
Table 1 HP-UX September 2012 (AR1209) Fixes
DescriptionDefect ID
Installing or updating the FCOC driver no longer requires a reboot if the driver is not in use.QXCR1001179851
This fixes a memory leak in the FCOC driver that occurs when a dynamic module unload is
executed.
QXCR1001217140
This fixes the issue where the FCOC driver hangs during dynamic loading (DLKM) when the
system is low in memory.
QXCR1001205908
This fixes a timing-related issue in the FCOC driver when an fcmsutil option is run while the driver
is being reset that may result in the driver hanging during unload.
QXCR1001209093
This fixes a timing-related issue in the FCOC driver that may cause a system panic if ELS requests
are in progress, especially when the driver is being reset or cable is being disconnected.
QXCR1001205379
QXCR1001215209
QXCR1001208629
Table 2 HP-UX March 2012 (AR1203) Fixes
DescriptionDefect ID
This fixes a timing-related hang issue in the FCOC driver that may occur when the driver is being
unloaded.
QXCR1001144340
This fixes fcocutil to print correct SFP information or print appropriate error message.QXCR1001146915
This corrects a resource issue that may result in the FCOC driver never coming online after
repeated disables, enables, and resets, and subsequently being stuck in
"AUTHENTICATION/DISCOVERY" state as reported by fcmsutil
QXCR1001126158
This corrects a resource issue that may result in a system panic during FCOC driver unload.QXCR1001103767
This corrects an issue that may result in a system panic during FCOC driver unload.QXCR1001158686
This fixes a FCOC dump failure when crossing every 4GB page boundary.QXCR1001159017
This corrects an issue that may result in the FCOC driver hanging during unload.QXCR1001115144
This fixes an issue where the moduload fails to unload fc module because it is busy.QXCR1001159730
This corrects a system panic that may occur when a target path goes offline.QXCR1001171646
This change corrects a driver issue that intermittently caused an HBA hang during a reset sequence.QXCR1001175013
FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview 3