FibrChanl-03 (fcoc) B.11.31.1209 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 2 HP-UX March 2012 (AR1203) Fixes (continued)
DescriptionDefect ID
This corrects a system panic that may occur when a target controller becomes less responsive.QXCR1001177226
This corrects an FCOC driver issue that may result in a system panic when a target controller
becomes less responsive.
QXCR1001180904
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
QXCR1001119607
Table 3 HP-UX August 2011 (WEB1108) Fixes
WEB1108 supersedes the AR1109 release.
DescriptionDefect ID
This addresses issues in the driver's IO state machine.QXCR1001137610
This enhances the driver's interrupt handling capabilities.QXCR1001124369
This fixes a failure case in dma mapping.QXCR1001141630
This fixes the dump driver's incorrect what string.QXCR1001146801
Added Fibre Channel support for the CN1100E HBA.QXCR1001174447
Added Fibre Channel support for the NC553M HBA.QXCR1001174449
Table 4 HP-UX September 2011 (AR1109) Fixes
DescriptionDefect ID
This fixes the issue where the fcoc driver may panic with “Bad News!” when a fcmsutil command
is being executed while DLKM unload operation is in progress.
QXCR1001122377
This fixes the issue where the fcoc driver may panic with “Bad News!” when concurrent fcmsutil
stat commands are being run.
QXCR1001129474
This fixes the issue where, after performing a port disable/enable sequence with fcmsutil, the
fcmsutil get remote all command would not display the correct data.
QXCR1001081641
The System Management Homepage will now display the correct SLI version in the HBA Adapter
Firmware Version field.
QXCR1001083098
The maximum IO size supported by the controller has been set at 1MB.QXCR1001115601
This fixes the issue where ioscan may not show the fcoc driver’s device special files (DSFs) when
a reboot is followed after FibrChanl-03 depot installation.
QXCR1001075202
This corrects a problem wherein a change to the allocated link bandwidth in the server profile
in the Virtual Connect Manager (VCM) failed to be displayed correctly in fcmsutil output without
QXCR1001088875
either rebooting, resetting, or disabling then enabling the FC HBA. In addition to the changes
made in the FCOC driver, this fix is dependent upon specific firmware versions in the FC HBA.
For the FlexFabric Adapter NC551m (580151-B21), the minimum firmware version required to
access this fix is 2.704.322.0.
Table 5 HP-UX March 2011 (WEB1103) Fixes
DescriptionDefect ID
This release fixes a problem in which when a port is disabled, SNIA does not display any port
or adapter attributes for other enabled ports.
QXCR1001070913
4