FibrChanl-03 (fcoc) B.11.31.1209 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes
6. On the same Emulex Adapter Configuration Main Menu screen, select Back to Display
Adapters and RECONNECT DEVICES and press Enter.
7. Type s to save the changes.
8. Exit the Emulex utility. Control B to go into cm and type rs to reset the system.
Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your FibreChannel
card.
Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-03 (fcoc)
driver, version B.11.31.1209, into a system:
• BL8x0c i2 System Firmware 15.05 or higher
• Superdome2 System Firmware 2.26 or higher
• rx2800 i2 System Firmware s26.21 or higher
• C7000 OA Firmware 3.20 or higher
• VCSU FW 1.6.0 or higher
• VC-Enet FW Version 3.15 or higher (for profile migration, 3.17 or higher is required)
• NC551m Firmware version 2.104.356.3 or higher
• NC553m Firmware version 3.104.356.3 or higher
• CN1100E Firmware version 3.104.356.3 or higher
• HP-UX 11i v3 OS Fusion version B.11.31.1103 or higher
• HP-UX CommonIO 11.31.1103 or higher
For current recommended firmware versions, see the HP-UX Fibre Channel (fcd, fclp) and FlexFabric
FCoE (fcoc) Host Bus Adapter Support Matrix at http://www.hp.com/go/hpux-iocards-docs, by
clicking onHP Fibre Channel Host Bus Adapters.
8