HP-UX Fibre Channel (fcd, fclp) and FlexFabric FCoE (fcoc) Host Bus Adapter Support Matrix, February 18, 2014

HP-UX Fibre Channel Host Bus Adapter support matrix Page 13 of 13
Adapter Hardware platform
Minimum system
firmware
requirements
Recommended
adapter firmware
Boot
support
Operating system
18
Driver bundle OL* support Notes
© 2004-2012 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional warranty.
Legal notices
1
Refer to Virtual Connect documentation for recommended versions of VC, OA, and other components.
2
Boot is supported through all 6 mezzanine ports (each blade can have a maximum of 3 mezzanine boards; each board has 2 ports), as well as through the Virtual Connect module.
3
Boot is supported through all 6 mezzanine ports (each blade can have a maximum of 3 mezzanine boards; each board has 2 ports).
4
Emulex 4 Gb Fibre Channel Mezzanine Cards (403621-B21) have been modified for compatibility with HP Integrity c-Class BladeSystems. Integrity-supported cards have an engineering date code (EDC) of B-4813 or greater.
5
HP recommends adapters in Superdomes be installed or replaced by a field service representative only.
6
For more information about LAN Boot, refer to the LAN Boot Overview on http://docs.hp.com under I/O Cards and Networking Software, and then Internet Transport.
8
11.11 (64 bits only)
9
A9782A are keyed for support in 3.3v slots only. For best performance, do not put the A9782A in a slot shared with other cards.
10
The rp7410 and rp7420 servers support LAN boot over the A9782A cards only in 2 slots, depending on what cells are in the PDE—the 2 slots can vary:
Cell 0: slots 0_1 and 0_2
Cell 1: slots 1_7 and 1_8
Both Cell 0 and Cell 1: slots 0_1 and 1_8
Maximum supported number of A9782A adapters is limited by the number of available PCI / PCI-X slots in any listed system.
Use PCI-X Slots for maximum performance.
12
For more information about LAN Boot, please refer to the LAN Boot Overview on http://docs.hp.com under I/O Cards and Networking Software, and then Internet Transport.
13
11.11 (64 bits only)
15
FCD supports multi-initiator NPIV in the Matrix OE 6.3. Please refer to Insight Software 6.3 documentation for more information.
16
Private and Public Loop topology configurations are not supported for FC Mezz adapters on HP Integrity Blade servers with 4Gb FC Pass Thru I/O Interconnect Modules.
17
FCoE outbound (uplink) is not supported at this time.
18
FCLP supports NPIV with HP-UX 11iv3 B.11.31.1303
19
HP-UX 11iv3 B.11.31.1303 operating system supports maximum 16 TB boot disk size with Logical Volume Manager (LVM) on Itanium platform. For more information refer HP-UX 11i Version 3 March 2013 Release Note.
Note
Notes