Data Protector Cluster Cell Manager Configuration and Integration on RHCS

4
/dev/DP_Grp/DP_Vol /FileShare gfs defaults 0 0
$mount /FileShare
$ mount –l
/dev/mapper/DP_Grp-DP_Vol on /FileShare type gfs
(rw,hostdata=jid=0:id=262145:first=1) [home:mygfs]
Installing Data Protector Cell Manager on each node
Installing and integrating on the primary node
Note: Data Protector v6.11 is used to install Data Protector’s Cell Manager on all the nodes. In
general, the procedure will work with later versions of Data Protector as well
.
1. Copy Data Protector rpm’s/ depots and the omnisetup.sh script to the /tmp folder of the
primary node, and run the omnisetup.sh script to install Data Protector on the primary node
.
$./omnisetup_243D.sh -source ‘pwd’ -CM -IS -build 243D
2. After installing Data Protector on the primary node, edit the file
/etc/opt/omni/server/sg/sg.conf as follows:
Figure 1: The file sg.conf, updated with mount point and hostname on the primary node
Note:
– FileShare is the mount point of the shared disk. It is created on all the nodes
.
– Dpi00180.ipr.com is the virtual server with a proper DNS entry. It acts as the Cell Manager
.
3. Check that the shared disk is mounted on the primary node by executing the df command as
follows:
$df
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/mapper/VolGroup00-LogVol00 19425972 3236244 15187028 18% /
/dev/sda1 101086 12613 83254 14% /boot