Brocade iSCSI Gateway Service Administrator's Guide (53-1000603-01, October 2007)

iSCSI Gateway Service Administrator’s Guide 17

53-1000603-01

Configuring the GbE interface

Adding ARP entries (optional)

ARP entries for the IP interfaces are created automatically when you verify the network connectivity

using the ping command. This command configures additional address resolution protocol (ARP)

entries.

NOTE

The GbE port number <port_number> below is entered geX; where X is from 0 through 7.

For example ge1 (see Figure 8 on page 12).

To automatically add ARP entries

1. Connect and log in to the switch.

2. Enter the portCfg arp add command as follows:

switch:admin> portcfg arp 3/ge0 add 30.0.30.11 00:0F:1F:69:99:88

Operation Succeeded

3. Verify the entry use the portShow command as follows:

switch:admin> portshow arp 3/ge0

Slot: 3 Port: ge0

IP AddressMac AddressFlags

-----------------------------------------------------------

30.0.30.214 00:c0:dd:07:81:13 Resolved

30.0.0.1 00:11:93:58:fd:7f Resolved

30.0.30.11 00:0f:1f:69:99:88 Permanent Resolved