Brocade iSCSI Gateway Service Administrator's Guide (53-1000603-01, October 2007)

iSCSI Gateway Service Administrator’s Guide 37
53-1000603-01
Chapter
4
Creating the iSCSI FC Zone
This chapter describes how to create an iSCSI FC zone for discovery domains (DDs).
NOTE
If you do not have a zoning license or if zoning is not implemented, you do not need to create a zone
for iSCSI target gateway service.
In this chapter
•Overview of iSCSI FC zoning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
•Creating an iSCSI FC zone. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
•Creating a zoning configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
NOTE
The configuration procedures covered in this chapter are also available through the Web Tools
Graphical User Interface as an alternative to the command line interface. Refer to the Web Tools
Administrator’s Guide for descriptions of GUI-based configuration procedures.
Overview of iSCSI FC zoning
After you have finished setting up the iSCSI target gateway, you create an iSCSI FC zone for
discovery domains. Depending on whether you have an effective zone configuration enabled in the
current fabric, you will be able to choose where to put the iSCSI FC zone. It can be either contained
in a defined configuration or integrated into the effective configuration. Figure 9 illustrates a
defined iSCSI FC Zone containing iSCSI virtual initiators and FC targets.