Brocade OS Command Reference Manual Supporting Fabric OS v6.0.0 (53-1000599-01, October 2007)

Fabric OS Command Reference 199

53-1000599-01

ficonCupSet

Sets FICON-CUP parameters for a switch.

Synopsis ficoncupset fmsmode enable | disable

ficoncupset modereg bitname 0 | 1

Description Use this command to set FICON-CUP (Control Unit Port) parameters for a switch. All the parameters

described below can be set while the switch is online. Changes to parameters are effective

immediately. A reboot is not required for the changes to take effect.

The execution of this command is subject to Admin Domain restrictions that may be in place.

Operands This command has the following operands:

fmsmode Enable or disable the FICON Management Server (FMS) mode for the switch.

When the operand is fmsmode, the argument is either enable or disable.

If you use PID Format 2, you cannot enable fmsmode.

modereg Set a bit in the FICON-CUP mode register. When the operand is modereg, one

of the following bitname operands should be specified, followed by 0 or 1:

POSC Programmed offline state control

UAM User alert mode

ASM Active=saved mode

DCAM Director clock alert mode

ACP Alternate control prohibited

HCP Host control prohibited

Examples To enable FMS mode for the switch:

switch:admin> ficoncupset fmsmode enable

fmsmode for the switch is now Enabled

To set ASM bit in the mode register for the switch:

switch:admin> ficoncupset modereg ASM 1

Active=Saved Mode bit is set to 1