Brocade OS Command Reference Manual Supporting Fabric OS v6.0.0 (53-1000599-01, October 2007)

284 Fabric OS Command Reference
53-1000599-01
ipAddrSet
2
1. When using the command line syntax to add or delete IPv6 addresses, the managed entity is
identified only on chassis-based platforms. To set the CP IPv6 address use the -cp option; to
set the switch IP address use the -sw option.
2. When using the command line syntax to add or delete IPv6 addresses on non-chassis-based
platforms, the implied entity is the single managed entity supported by the platform and must
be left unspecified.
3. Additionally, the -eth0, -eth1, and -gate command line options are available with the --add or
--delete option on platforms with blade processors to set the BP Ethernet or Gateway
addresses. On a chassis-based system with a blade processor the values for the blade in slot n
can be set from the command line using the -slot option. The -slot option is not accepted in
standalone application processors with a hidden blade, such as the AP7600.
The execution of this command is subject to Admin Domain restrictions that may be in place. For
additional restrictions, refer to the Fabric OS Administrator Guide.
Operands This command has the following operands:
When used interactively to configure IPv4 addresses on a chassis-based system:
-cp number Valid options include:
0 Sets the Ethernet IP address, Ethernet subnetmask, gateway IP address,
and host name of CP0.
1 Sets the Ethernet IP address, Ethernet subnetmask, gateway IP address,
and host name of CP1.
-sw number Valid options include:
0 Sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP
address, and Fibre Channel subnetmask of logical switch 0.
1 Sets the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP
address, and Fibre Channel Subnetmask of logical switch 1.
When used in command line mode, the following operands are supported:
-IPv6 Specifies IP address type as static IPv6.
--add Specifies an address with prefix as needed.
--delete Specify an address to be deleted. If no address is specified, any existing IPv6
addresses and prefixes will be deleted from the specified or implied entity.
-cp number | -sw number
On a chassis-based system, specify CP or logical switch. Valid values for
number are 0 or 1.
On platforms with blade processors, the following additional command line options are supported
with the --add or --delete options:
-eth0 |-eth1 Specify local IPv4 address of blade processor. Prefix required.
-gate
Specify IPv4 address of blade processor (BP) Gateway (no prefix).