Brocade OS Command Reference Manual Supporting Fabric OS v6.0.0 (53-1000599-01, October 2007)

456 Fabric OS Command Reference
53-1000599-01
portCfgShow
2
portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [[slot/]port]
portcfgshow option [slot/][ge]port [args] [optional args]
Description Use this command to display the current configuration of a port.
If no operand is specified, this command displays port configuration settings for all ports on a
switch, except gigabit Ethernet (GbE) ports. Additionally, use this command with optional
arguments to display specific FCIP parameters configured for a gigabit Ethernet port, such as the
following:
• Address resolution protocol (ARP) entries
• IP interfaces on the GbE port
• Static routes on the IP interfaces
• Fibre Channel over IP (FCIP) tunnel configuration settings
- IKE and IPSec policy information
- QoS mappings
• Port Mode information
• VLAN tag configuration
The output of this command may vary depending on the hardware platform and port type.
The execution of this command is subject to Admin Domain restrictions that may be in place.
The following information is displayed when the command is issued for all ports, or for a specific
port:
Speed Displays 1G, 2G, 4G, 8 GB or AN (when in auto speed negotiation mode). This
value is set by the portCfgSpeed command.
AL_PA Offset 13 Displays the arbitrated loop physical address (AL_PA) offset. Displays (...)/OFF
when the AL_PA Offset is 0x0 (default). Displays ON when AL_PA Offset is
0x13. This value is set by the portCfgAlpa command.
Trunk Port Displays ON when port is set for trunking or (..)/OFF when trunking is disabled
on the port. This value is set by the portCfgTrunkPort command.
Long Distance Displays (...)/OFF when long distance mode is off; otherwise, displays long
distance levels as follows:
LE The link is up to 10 km
LM The link is up to 25 km
L1 The link is up to 50 km
L2 The link is up to 100 km
LD The distance is determined dynamically
LS The distance is determined statically be user input
This value is set by the portCfgLongDistance command.