Brocade OS Command Reference Manual Supporting Fabric OS v6.0.0 (53-1000599-01, October 2007)

Fabric OS Command Reference 575
53-1000599-01
setModem
2
In the recommended configuration, a separate modem is connected to each modem port of CP0
and CP1. These modems connect to the telephone outlet through a RJ-11 Y-adapter and standard
telephone wire (see Figure ) is attached to the wall outlet.
During an incoming call, both modems ring and the one connected to the active CP answers the
call first. If for any reason the active modem fails to answer, the caller is logged in to the standby
CP.
Operands The optional operands are as follows:
-e Specifies that modem dial-in be enabled.
-d Specifies that modem dial-in be disabled.
Examples To disable modem dial-in to a CP:
switch:admin> setmodem -d
disabling modem, please wait, this can take a couple of minutes...
modem disabled
See Also none