Brocade Web Tools Administrator's Guide (53-0000194-01, November 2006)

Web Tools Administrator’s Guide 9-15
Publication Number: 53-0000194-01
9
The Add Member button becomes active.
6. Click Add Member to add QuickLoop members.
Selected members are moved to the QuickLoop Members area.
7. Optional: Repeat steps 6 and 7 to add a second element to your QuickLoop.
At this point you can either save your changes or save and enable your changes.
8. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see “Enabling Zone Configurations” on page 9-23.
Adding and Removing Members of a QuickLoop
Use the following procedure to add or remove members of a QuickLoop.
To modify the members of a QuickLoop
1. Launch the Zone Administration module as described on page 9-3.
2. Click the QuickLoop tab.
3. Select the QuickLoop you want to modify from the Name drop-down menu.
4. Select an element in the Member Selection List that you want to include in the QuickLoop, or
select an element in the QuickLoop Members that you want to delete.
5. Click Add Member to add a QuickLoop member or Remove Member to remove a QuickLoop
member.
At this point you can either save your changes or save and enable your changes.
6. Click Zoning Actions > Save Config Only to save the configuration changes.
To enable the configuration, see “Enabling Zone Configurations” on page 9-23.
N
ote
There is a limit of two members per QuickLoop. Only switches capable of running
QuickLoop are displayed in the Member Selection List.
N
ote
There is a limit of two members per QuickLoop. Only switches capable of running
QuickLoop are displayed in the Member Selection List.