Brocade Web Tools Administrator's Guide (53-0000194-01, November 2006)

15-8 Web Tools Administrator’s Guide
Publication Number: 53-0000194-01
15
When you select one of the GbE ports, you can perform the same tasks listed previously: view and
capture statistics related to the port, add or delete IP addresses, add or delete IP routes, view current
sessions, and view the iSCSI statistics in brief.
Figure 15-3 iSCSI Port Tab
If an IP address or IP route is already configured on the GbE port, then it will not be editable as any
edits will disrupt any iSCSI traffic.
Configuring the IP route is optional because when an IP address is set up, a route is automatically set up
as well. If the automatically created route is unwanted, you can delete it and create one that suits your
networking needs.
To configure the IP address
1. Launch the iSCSI Target Gateway Admin module as described on page 15-6.
2. Select the iSCSI Port tab.
3. In the left pane, select the GbE port that will be used.
4. Select the IP Interface tab and click Add.
5. Enter the IP address and subnet mask.