HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

Message Explanations and Actions
103
Replacement of lens
cover recommended→
The printhead alignment procedure, or the printhead check procedure, or a
calibration check has failed because the lens cover is dirty and needs replacing.
Printing may continue but the image quality is not assured.
Press ↓ to continue. See the instructions for lens cover replacement on page
10-3, Lens Maintenance in the Users Guide. Spare lens covers are inside the
right door.
Resource area full
Unable to save res.
(HP DesignJet 2500CP only) The printer’s hard disk is full. You are attempting
to save resources. The printer is unable to process the request.
You need to remove some of the resources from the hard disk, for example,
saved print files, halftones, or fonts that you don’t use. Then try saving the
resource again.
Roll empty
Load new roll
You have used all of the media roll.
Load a new roll of media.
Roll misaligned
Reload roll
Roll media is skewed.
Reload media.
Set transport→ Yes
Mode→ No
You have selected transport mode in the front-panel menu. The printer is
waiting for you to accept or reject the transport mode. Accepting transport
mode starts the process of removing all ink systems.
Press ↑ to accept or press ↓ to reject.
Sheet load→
Roll load→
Press ↑ to load sheet media.
Press ↓ to load roll media.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 103 Tuesday, July 28, 1998 5:31 PM