HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

0HVVDJH([SODQDWLRQVDQG$FWLRQV
104
Sheet misaligned
Reload sheet
Sheet media is skewed.
Remove it and reload it so that the left and right edges being loaded into the
printer are square. The leading edge must also be straight.
Sheet required
for calibration
You have started an accuracy calibration check but media is not present.
Load media.
Sheet / Roll?
Reload media
Either: Sheet mode was chosen while loading roll media.
Reload media.
Or: a sheet more than 51 inches (130 cm) long was loaded.
Trim the sheet and reload.
STATUS messages See pages 107 through 112.
Switch power off You have selected the transport mode shut-down sequence. The printer is
waiting for you to turn the power switch, on the rear of the printer, to off.
Switch off the printer.
Switch power off
Check paper path
The printer may be jammed with media.
Turn off the printer. Check the media path and clear it if necessary. Then turn
on the printer.
Switch power off
Check printhead path
The printhead carriage cannot move. The printer may be jammed with media.
Turn off the printer. Check the media path and clear it if necessary. Then turn
on the printer.
0HVVDJH ([SODQDWLRQDQG$ FWLRQ
qrgbook.bk.fm Page 104 Tuesday, July 28, 1998 5:31 PM