HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

Message Explanations and Actions
105
System Error
060000
The ambient light level in the area of your printer is too bright and is causing
the optical sensor in your printer to malfunction.
Reduce the ambient light level or move the printer to a location where the light
level is lower.
System error
XXXXXX
An internal error has occurred and a system error number is displayed.
Press
Enter; this may clear the error and allow you to continue. If you cannot
continue, turn off the printer, and then turn it on again. If you still see the
system error message, record the system error number and call HP to have the
printer serviced.
System error
XXXXXX XXXXXXXX
An internal error has occurred and a system error number is displayed.
Press
Enter; this may clear the error and allow you to continue. If you cannot
continue, turn off the printer, and then turn it on again. If you still see the
system error message, record the system error number and call HP to have the
printer serviced.
trim edge→
continue→
The Take Up Reel is turned on and you are about to load the media onto it, you
now have the option of trimming the edge or to continue. You only need to trim
the edge if the media was damaged in the loading process or is not straight, It
is important when loading media onto the Take Up Reel that the media is taped
onto the core tube straight.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 105 Tuesday, July 28, 1998 5:31 PM