HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

0HVVDJH([SODQDWLRQVDQG$FWLRQV
106
UV inks YES→
installed NO→
After you have finished installing a new ink cartridge, you are asked to confirm
that you have changed the type of ink cartridges from Imaging to UV
Pigmented.
Press ↑ to confirm that you have changed the ink cartridges from Imaging to
UV Pigmented.
Press ↓ to indicate that you have not changed the ink cartridges from Imaging
to UV Pigmented. You will then be given the opportunity of replacing the
incorrect ink cartridges by the correct ones.
Verify ink system
■■❏■→
At power-on, the printer has detected an error in the ink systems shown by
flashing squares.
Press ↓ to continue. You should check the ink systems immediately; see 68,
Checking Ink Systems.
Wind the Take Up
Reel
Cut→
You are removing media from the Take Up Reel. Before you Cut the media to
remove it, you must wind up the media onto the Take Up Reel or the media will
fall to the floor and possible damage it.
Press the wind button on the Take Up Reel and then press the ↓ key to cut the
media.
0HVVDJH ([SODQDWLRQDQG$ FWLRQ
qrgbook.bk.fm Page 106 Tuesday, July 28, 1998 5:31 PM