HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

5HSODFLQJWKH,QN 6\VWHP
58
After you replace the ink system, the printer performs some checks and alignments. If no media is
loaded, the printer will display the message “Load media to align printheads.” Load media following
the directions on page 32, Removing a Roll from the Printer, or page 37, Changing the Core Tube on
the Take Up Reel. The alignment procedure requires a minimum media size of A3 or B-size.
When the front panel displaysSTATUS Ready”, you are ready to print.
NOTE Make sure the printer window and the left and right doors are closed after you
replace ink system components. The printer will not print while any doors are
open.
qrgbook.bk.fm Page 58 Tuesday, July 28, 1998 5:31 PM